BANGKOK
electric
wok
27607_IM.indd
1
2013/07/05 08:56:23 AM
SPECIFICATIONS
Capacity:4.20 liters
Voltage :AC 230 / 50Hz
Wattage :1500W
2. DO NOT pour cold water into a hot Electric
Wok
3. Hold the unit at a 45°angle, this will prevent
or at-least minimize the water getting into the
socket.
USING YOUR ELECTRIC WOK
4. Never scrape with hard or sharp utensils
while cleaning. Do not use harsh abrasive
cleaners, products or utensils that are not
considered safe to use on nonstick coatings.
You must read all instructions before using.
1. Remove all packing material and please
check carefully to ensure that your Electric
Wok is in good condition. It must not have 5. Wash the Electric Wok after each use to
any cracks on the unit and no damage to the
power cord/plug.
2. Wash the wok in warm, soapy water. Rinse
and dry thoroughly.
3. Place wok on a dry and level countertop or
table. Keep the edge of the wok 5-10cm
away from any walls and objects on the
countertop or table.
avoid stains caused by a build-up of food
or grease residues. Never leave food in the
Electric Wok overnight.
6. With the wok turned off and completely cold,
condition the surface with 1 to 1-1/2 table-
spoons of cooking oil; use a kitchen paper
towel to wipe it thoroughly.
4. Check the handles on a regular basis to en- NOTE:
sure that they are firmly attached to the wok. •Temperature Control Probe - If cleaning is
5. Do not use abrasive cleaners or scouring
pads.
6. Do not immerse the wok, power cord or plug
in water at any time.
necessary, wipe it with a damp cloth. NEVER
IMMERSE THE TEMPERATURE CONTROL
PROBE IN WATER AND ANY OTHER LIQ-
UIDS. Always ensure that the probe is com-
pletely dry before inserting it into the socket.
TO COOK
1. Attach the thermostat to the wok and plug it •Electric Wok - Wash the inside surface of
into the wall socket.
the Electric Wok in hot soapy water, using a
sponge or soft cloth. Do not use any harsh
abrasive cleaners. Normal dish washing liquid
should be sufficient. Rinse and dry thoroughly,
try not to get any water into the socket but if
by chance this happens, always ensure the
socket is completely dry before inserting the
control probe.
2. Add cooking oil and adjust the cooking tem-
perature to the desired setting. When the
indicator light goes off, the temperature has
been reached and the wok is ready.
3. Do not cover the wok with the lid when heat-
ing up the cooking oil.
4. When cooking is complete, move the tem-
perature dial to “0” position and take food
out of the wok.
•Glass lid - Always ensure the glass lid has
cooled down before cleaning. Wash the lid in
warm soapy water using a soft sponge, rinse
and dry thoroughly.
Remove the plug from the wall socket immedi-
ately after you have finished cooking. When the
wok has cooled down, remove the thermostat.
Allow the wok to cool completely before clean-
ing.
CARE AND CLEANING
Always ensure that the Electric Wok has cooled
down completley and that it is is unplugged be-
fore cleaning. Following a few general tips can
prolong the life of your Electric Wok.
1. Move the temperature dial to the “Off” posi-
tion and unplug the power cord immediately
after cooking.
27607_IM.indd
3
2013/07/05 08:56:23 AM
27607_IM.indd
4
2013/07/05 08:56:24 AM
|