Marshall
V-R563P Instruction Sheet
B r o a d c a s t M u l t i m e d i a D i v i s i o n
The V-R563P is a rack mounted unit that has three independently controlled 5.6” active matrix LCD panels with loop
through capability. These 5” panels have 960x234 pixels making them a true high resolution LCD panel. This unit also
has a unique feature that allows the unit to tilt up or down for optimum viewing angle. The unit fits into a EIA standard
19” rack, three rack spaces high. Each of the three screens has individual front mounted selector buttons with LED’s
and color, tint, brightness and contrast controls. Each screen has two composite video inputs wit loop through and a
built-in color bar generator. Unit comes complete with power supply and is available in either NTSC or PAL format.
The operation of the V-R563P is fairly straightforward, however, it is important to take note of the following:
1. The V-R563P has been designed to fit in a 3U space on your rack. It may be necessary to center the unit up
or down in order to not touch any adjacent units in your rack when tilting unit up or down.
2. Each LCD Panel comes with a protective plastic film that must be removed by carefully lifting the film from
the corner and peeling it off. Be certain not to apply any pressure on the LCD panels, they are fragile and can
break. Scratched, cracked or broken LCD screens are not covered by our warranty.
3. The V-R563P uses 12VDC, 2.0amp regulated power. Be certain that these specifications are met when using a
power supply other than the one supplied to you by Marshall Electronics.
4. The polarity configuration for the V-R563P is indicated on the rear panel of the unit. Any battery operation of
the V-R563P must have this polarity configuration.
5. The Video inputs on the rear of the panel are 75 Ohm self-terminated. The loop through feature uses active
components and is always active as long as power is supplied to the unit regardless of the monitor being ON or
OFF.
2.5”
Rear View
Side View
Picture
Power
Display
Viewing Area
Dot Pitch
Inputs
Color Bars
Dimensions
Elements
Consumption
5.6” LCD
4.46” x 3.33” 0.118mm x
2 NTSC/PAL
per panel
19.125W x
5.14H x 2.5D
12 VDC
2.0 Amps
Built into unit
960H x 234V
Active Matrix each panel
0.362mm
|