Model SW7001 User Guide
Subwoofer
Thank you for purchasing the Marantz SW7001 Subwoofer.
BEFORE USING
Before using this unit, please read the User Guide carefully to ensure
proper operation of the unit, and retain it together with the supplied
warranty.
This section must be read before any
connection is made to the mains supply.
• To ensure proper heat radiation, ensure
the below clearance from walls and other
equipment.
7 Equipment mains working
7 Accessories Check
Rear 4 ins. (0.1 m) or more
setting
Before use, check the below accessories were included in the package.
Your Marantz product has been prepared to
comply with the household power and safety
requirements that exist in your area.
• Audio cable
• Remote control cable
• User Guide (This manual)
This unit can be powered by 120V AC only.
• Warranty Card
(USA x 1, Canada x 1)
7 Copyright
Recording and playback of any material may
require consent. For further information refer
to the following:
7 Keep Objects Off
Keep objects off the unit.
– Copyright Act 1956
– Dramatic and Musical Performers Act
1958
CONTENTS
7 Do not touch hot spots during
and immediately after use
– Performers Protection Acts 1963 and 1972
BEFORE USING .......................................................................................... 1
During and immediately after use, the unit
is hot in areas other than the controls and
rear panel connection jacks. Do not touch hot
spots and especially the rear panel. Contact
with hot areas can cause burns.
– Any subsequent statutory enactments and
orders
NAMES AND FUNCTIONS OF PARTS....................................................... 2
FRONT PANEL.................................................................................................... 2
FRONT PANEL.................................................................................................... 2
7 Do Not Locate in the Following
CONNECTIONS........................................................................................... 3
INSTALLATION............................................................................................ 3
SPECIFICATIONS ....................................................................................... 4
OTHERS ...................................................................................................... 4
Places
To ensure long-lasting use, do not locate the
unit where:
7 Cautions on handling power
cord
• Exposed to direct sunlight.
• Near to sources of heat such as heaters.
• Highly humid or poorly ventilated.
• Dusty.
• Do not touch the power cord with wet
hands.
• When disconnecting the power cord,
always make sure that you take hold of the
plug. Yanking out or bending the cord can
damage it and/or cause electric shocks or
a fire.
• Subjected to mechanical vibrations.
• On wobbly, inclined or otherwise unstable
surfaces
• Get into the habit of disconnecting the
power plug before leaving home.
• On a high place such as on a TV set
1
NAMES AND FUNCTIONS OF PARTS
w STANDBY indicator
r INPUT jack
FRONT PANEL
REAR PANEL
This indicator shows the status of the
unit’s power.
The indicator lights in green when the unit
is turned on.
This is an audio input jack used to connect
to the subwoofer output jack of the optional
ES7001 or a commercially available AV
amplifier.
INPUT CONTROL IN
MODEL NO.. SW7001
It lights in red when the unit is in standby
mode.
AC OUTLETS
t CONTROL IN jack
This is a control signal input jack used to
connect to the SUB W. CONTROL OUT
jack on the optional ES7001.
In conjunction with the power on/off on the
ES7001, this unit is turned on/off.
Note:
The power consumption in standby
mode is approximately 0.5 W. We
recommend you turn off the unit when
it is not in use.
UNSWITCHEDD 350W MAX
120V 60Hz
AC IN
Note:
POWER ON/STANDBY
+
–
VOLUME
e VOLUME -/+ knob
Connection with any equipment other
than the ES7001 may cause damage
to the unit.
This knob is used to adjust the volume.
Turning it clockwise increases the volume.
q w
e
rty u
y AC OUTLET
q POWER ON/STANDBY button
Notes:
These AC outlets supply power to the
optional ES7001, DVD player, etc.
Setting the volume of the connected
amplifier to an excessively high level
may cause sound deterioration or
damage to the unit. Please note the
following when you use the unit with an
amplifier connected.
This button is used to switch between
power-on and standby mode. When the
unit is turned on and no audio signal is
input for several minutes, the unit’s auto
power-on/standby-function is activated
and the unit automatically goes into
standby mode.
When the CONTROL IN jack of the unit is
connected to the SUB W. CONTROL OUT
jack of the ES7001 HomeTheater System,
this unit is turned on or goes into standby
mode in conjunction with the operations of
the ES7001.
• The AC outlets are capable of supplying
power even if the unit’s power is turned
off.
• The AC outlets are capable of supplying
power to audio equipment which
requires a total power consumption of
up to 350 W.
• Do not set the unit’s volume too high
when the bass level is excessively
increased with the tone or loudness
controls on the connected amplifier.
Note:
Never connect a TV set, electric cleaner,
hair dryer, etc.to these AC outlets.Doing
so may cause damage to the unit.
• Set the volume control of the
connected amplifier to the minimum
level when you switch on the
amplifier’s power.
u AC power cord
Note:
The unit’s auto-power-on/standby
function is available only when the
control connection is made with the
ES7001.
Connect to a wall outlet capable of
supplying AC 120 V 60 Hz.
2
CONNECTIONS
INSTALLATION
• Use the connecting cables supplied with this unit when connecting with the ES7001 Home Theater System.
Notes:
• If the unit is turned on after connection with the ES7001, the unit goes into standby mode or turns on in conjunction with operation of the
ES7001. (Subwoofers of other manufacturers do not work in conjunction with the ES7001.)
• Install the unit near the wall outlet so that
the AC power cord is easily disconnected.
• The unit is not disconnected from the AC
power source even if the unit is turned off.
To disconnect it from the AC power source
completely, unplug the unit from the wall
outlet.
Notes:
Do not connect the AC power cord of the unit to the wall outlet before making all connections.
• Insert all connecting cable plugs firmly into the connectors. A loose connection may result in no sound or noise.
• Be sure to unplug the unit when connecting or disconnecting the cables. Connecting or disconnecting the cables without unplugging may cause
a malfunction or breakdown of the unit.
7Unit’s anti-magnetism and
7Connecting the unit
interference with a TV picture
This unit is an anti-magnetic type subwoofer,
but if the unit is located near a TV, the colors
may become spotty. If this occurs, place the
unit further away from the TV.
• Connect the INPUT jack on this unit to the SUB W. PREOUT jack on the ES7001.
• Connect the CONTROL IN jack on this unit to the SUB W. CONTROL OUT jack on the ES7001.
7Howling
When the unit is placed near an analog record
player, the output sound from the unit may
cause the installation surface and ambient air
to vibrate, producing howling. If this happens,
install the unit further away from the analog
record player or decrease the volume level of
the unit.
INPUT CONTROL IN
MODEL NO. SSW7001
AC OUTTLETS
In rare cases, howling may occur with a VCR,
compact disc player, mini-disc player or DVD
player and result in deterioration of sound
and picture. In this case, place the unit further
away from the equipment or decrease the
volume.
SUB W. PREOUT
UNSWITCHEED 350W MAX
120V 60Hz
AC IN
SUB W.
CONTROL OUT
Rear of SW7001
Right side of ES7001
3
SPECIFICATIONS
OTHERS
The section describes the care and
maintenance tasks that must be performed
to optimize the operation of your Marantz
component.
Power amplifier section
Dimensions / Mass
7 Repairs
¶
¶
Rated output...........50 W (EIAJ 100 Hz, 4 Ω)
Line input sensitivity ...........................220mV
Frequency characteristics..........38Hz–170Hz
Width .............................. 231 mm (9-1/8 ins.)
Height ....................................203 mm (8 ins.)
Depth.......................... 312 mm (12-5/16 ins.)
Mass ....................................6.2 kg (13.7 lbs)
Only the most competent and qualified
service technicians should be allowed to
service the factory-trained warranty station
personnel have the knowledge and special
facilities needed for repair and calibration of
this precision equipment. After the warranty
period has expired, repairs will be performed
for a charge if the equipment can be returned
to normal operation.
Speakers
¶
7 Cleaningofequipmentexternal
Enclosure.............................. bass reflex type
Speaker unit ................................16 cm cone
Rated impedance .....................................4 Ω
Supplied accessories
¶
surfaces
Audio cable.................................................. 1
Remote control cable................................... 1
User Guide (this manual)............................. 1
Warranty card (USA x 1, CANADA x 1)....... 1
The exterior finish of your unit will last
indefinitely with proper care and cleaning,
Neverusescouringpads,steelwool,scourging
powders or harsh chemical agents (e.g., lye
solution), alcohol, thinner, benzine, insecticide
or other volatile substances as these wil mar
the finish of the equipment. Likewise, never
use cloths containing chemical substances.
If the equipment get dirty, wipe the external
surfaces with a soft, lint-free cloth.
Power supply
¶
In the event of difficulty, refer to your dealer or
write directly to the nearest location to you that
is listed on the Marantz Authorized Service
Station list. If writing, please include the model
and serial number of the equipment together
with a full description of what you think is
abnormal about the equipment’s behaviour.
Power requirements..............AC 120 V 60 Hz
Rated power consumption..................... 60 W
Power consumption in standby mode... 0.5 W
Note:
The speaker nets cannot be removed.
Dimensions
¶
312 (12-5/16)
7
302 (11-15/16)
3
(1/8)
231 (9-1/8)
(5/16)
If the equipment becomes heavily soiled:
• dilute some washing up liquid in water, in
a ratio of one part detergent to six parts
water.
• dip a soft, lint free in the solution and wring
the it is damp.
• wipe the equipment with the damp cloth.
• dry the equipment by wiping it with a dry
cloth.
Unit:mm (inch)
Specifications subject to change without prior notice.
4
You can find your nearest authorized distributor or dealer on our website.
is a registered trademark.
Printed in Malaysia
07/2007 00M38CW851250 mzh-d
|