User’s Manual
LA-125 / LA-126 Antenna Kit
LA-126 Antenna Kit (216MHz) shown
Use with:
LT-800-072 Stationary Transmitter
LT-800-216 Stationary Transmitter
LR-100-072 Stationary Receiver /
Power Amplifier
LR-100-216 Stationary Receiver /
Power Amplifier
Don’t miss a single sound. Listen.
Listen Technologies Corporation
8535 South 700 West, Suite A
Sandy, Utah 84070-2515 U.S.A.
Telephone: 1.801.233.8992
Toll Free (North America): 1.800.330.0891
Fax: 1.801.233.8995
E-mail: [email protected]
Table of Contents
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Contact . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Specifications
Antenna Lengths
LA-125(72 MHz):
9.2 in (23 cm)
LA-126 (216 MHz):
5.0 in (12.7 cm)
Coaxial Cable
RG58, 50 Ohms, 18 in (45.7 cm) length with standard
BNC connectors
BNC feed-through:
Shipping Weight:
Standard BNC to BNC 50 ohm coaxial connectors
1 lb. (.45 kg)
Installation Instructions
Before you begin:
A. This optional antenna can be installed only in the
single unit rack mount configuration.
B. Coverage of this antenna is not as
good as coverage provided by other
types of antennas because of its close
proximity to the rack.
C. When using this optional antenna,
mount the assembly as high as possible
in the rack.
LA-326 Rack Mount Kit shown with LA-126 (216MHz)
Antenna installed
Remove the rubber plug and mount the BNC feed-
through on the right rack mount bracket. Place the
rubber grommet on the front side of the bracket and
the lockwasher and nut on the back side. Tighten the
nut to hold the BNC feed-through in place.
rubber plug
Attach the BNC-BNC coaxial cable to the back side
of the BNC feed-through and to the BNC connector
on the rack mounted unit.
Install the 90 degree helical antenna to the front of
the BNC feed-through. Orient it vertically.
2
Warranty
Listen accessories carry a limited 90 day warranty. This warranty is only available
to the original end purchaser of the product and cannot be transferred. Certain
conditions apply. The terms of the warranty are governed by the laws of the state
of Utah. Listen will only accept returned products with prepaid shipping and with
a return authorization number. To receive a return merchandize authorization
number call 1.800.330.0891 or 1.801.233.8992. If the product was purchased
through a dealer, refunds must be processed through the original dealer.
This limited warranty, prices and the specifications of products are subject to
change without notice. For complete warranty information, visit the Listen
Contacting Listen
If technical service is needed, please contact Listen. Pre-authorization is
required before returning Listen products. If products were damaged in
shipment, please contact the carrier, then contact Listen for replacement or
repair requirements payable by the carrier.
Listen’s corporate headquarters are located in Sandy, Utah and are open
Monday through Friday, 8am to 5pm Mountain Time.
Web Site:
Email:
Address: 8535 South 700 West
Suite A
techsupport@ListenTech.com
Sandy, UT 84070-2515
U.S.A.
Phone:
Fax:
1.801.233.8992
1.800.330.0891 (North America)
1.801.233.8995
3
Listen Technologies Corporation
8535 South 700 West, Suite A
Sandy, Utah 84070-2515 U.S.A.
Telephone: 1.801.233.8992
Toll Free (North America): 1.800.330.0891
Fax: 1.801.233.8995
E-mail: [email protected]
|