PERSONAL AM/FM
STEREO CASSETTE PLAYER
MODEL 1126
Operating Instructions
PLAYS ALL STEREO CASSETTE TAPES
RECEIVES AM/FM BROADCASTS
STEREO HEADPHONES INCLUDED
BUILT-IN BELT CLIP
•
•
•
•
•
REQUIRES 2 SIZE “AA” BATTERIES (NOT INCLUDED)
PLEASE READ CAREFULLY BEFORE USE
IB-1126(CL)-WM-E-070506
LOCATION OF CONTROLS
2
3
1
9
8
4
5
6
7
1. FUNCTION SWITCH
2. TUNING CONTROL
6. PLAY
7. STOP BUTTON
8. BELT CLIP (at the back of the
set)
9. BATTERY DOOR (at the back
of the set)
BUTTON
3. STEREO HEADPHONES
4. VOLUME CONTROL
5. FAST FORWARD BUTTON
(FAST F.
JACK
)
READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
This personal cassette player is one of the most exciting and innovative
consumer electronics products ever developed. With it you can now enjoy
listening to your favorite music wherever you go, through the supplied
headphones .
But, for YOUR comfort, health and safety be sure to observe the following
guidelines.
HEARING COMFORT & WELL-BEING
Do not play your headphones at a high volume. Hearing experts advise
•
against continuous extended play.
If you experience a ringing in your ears, reduce volume or discontinue use.
•
TRAFFIC SAFETY
Do not use while operating a motorized vehicle. It may create a traffic
•
hazard and is illegal in many areas.
You should use extreme caution or temporarily discontinue use in
•
potentially hazardous situations.
Even if your headphones are an open-air type designed to let you hear
•
outside sounds, do not adjust the volume too high so that you can hear
what is around you.
2
IB-1126(CL)-WM-E-070506
Congratulations! You now own a personal radio cassette player, able to offer
personal listening with your headphones.
BATTERY INSTALLATION
Slide the BATTERY DOOR as the arrow direction to open it, and insert 2 size
“AA” batteries, taking care not to reverse the positive and negative polarities.
Alkaline batteries are recommended and will normally
provide more playing time.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
•
•
NOTE:
Remove both batteries during long periods (about 30 days or more) of
•
•
non-use, possible battery leakage and corrosion can damage the set.
If the sound becomes weak and unclear, the batteries may be weak. Replace
both batteries at once.
LISTENING TO THE RADIO
You may listen to the radio through the stereo headphones.
1. Plug the headphones plug into the HEADPHONES
2. Slide the FUNCTION switch to AM or FM position.
jack.
3. Select the desired station with the TUNING control (adjust for clearest
sound).
4. Adjust the VOLUME
control for the most pleasing sound.
5. When listening is completed, slide the FUNCTION switch to the TAPE
(RADIO OFF) position.
As the headphones cord functions as the FM antenna, do not bunch it up.
Unwind and extend the cord as much as possible.
3
IB-1126(CL)-WM-E-070506
AUTOMATIC STOP - This set will automatically shut itself off when the tape
has finished playing, and the PLAY
button will pop up.
TO INSERT THE TAPE
1. Open the cassette door by holding the door as shown and gently pulling
it to you.
2. Insert a recorded tape into the cassette holder ON THE DOOR.
3. Close the cassette door gently till it clicks shut.
CAUTION: Do not pull door too strongly, or you may damage the door. T
this set with care and it will last a long time.
TAPE PLAY
1. Check whether or not the tape is tight before it is inserted.
To keep the tape from tanglg, fi
wind the tape before insertg it int
player.
Use of a cassette h more tha
minutes, sucas C-120 (
minutes), is noecommended.
extreme thiss of this tape
damage thet.
2. Open the cassette door by hand, face the sidbe played toward you,
insert the cassette tape. Close the casseoor.
3. Connect the headphones to the HEAONES
headphones band for proper fit.
jack and adjus
4. Press the PLAY button.
5. Adjust the VOLUME
to cl the sound level you like.
button.
6. To skip portions of the cassepe, press the FAST F.
7. To stop playing, press the P button, and the power source is
shut off.
(This set has a builtto-stop and the tape mechanism will s
playing and shut on it reaches the end of the tape.)
8. To hear the othef tape, flip it over and press PLAY
.
TO HEAR TAME SONG AGAIN
1. Remove thflip it around to the other side and insert it.
2. Press thF.
button for a short time.
3. Remoflip it around to the original side, re-insert and press
PLAon.
4
IB-1126(CL)-WM-E-07
CLEANING TAPE HEAD
PINCH ROLLER
MAGNETIC HEAD
COTTON SWAB
If the sound drops out or excessive
noise occurs, clean the magnetic head,
capstan and pinch roller with a cotton
swab moistened with alcohol.
CAPSTAN
TROUBLE SHOOTING
PROBLEM
CHECK THE FOLLOWING
Is the headphones plugged into the jack?
- Plug it in now.
Is the VOLUME
control at minimum?
No sound.
- Raise the volume.
Are the batteries old or dead?
- Replace both batteries.
The tape has reached the end. Remove the tape,
flip it over to the other side and insert into cassette
PLAY button will
not stay down.
door and press PLAY
.
Rotate the set for better AM or bring it closer to a
window. For FM, extend the headphones wire
straight.
AM/FM reception
weak.
1. Check if both batteries are fresh and inserted
correctly.
2. Use a tape cleaning cassette tape to clean the
tape head (available at most radio stores).
Poor quality
playback after
playing a long
time.
Tape stops in
middle of play.
Try a different tape. Tape may be damaged. Also
try fast forwarding tape till the end.
1. Use only better quality tapes.
Tape jamming or
tangling.
2. Do not use a cassette with more than 90 minutes.
3. Make sure there are no loose layers of tape
visible before inserting the cassette.
NORMAL BATTERY LIFE USING ALKALINE BATTERIES IS ABOUT
11 HOURS OF CASSETTE PLAYING TIME.
5
IB-1126(CL)-WM-E-070506
GENERAL SPECIFICATION
Output power (Max)
Power source
: More than 20 mW/ch
: 2 size “AA” alkaline batteries (not included)
Tape Section
Speed deviation
Frequency response
: +3% -2%
: Standard normal bias cassette tape
100Hz – 8kHz
Radio Section
Frequency range:
FM: 88 – 108 MHz
AM: 530 – 1700 kHz
LIMITED WARRANTY
We warrant this product to be free from defects in material and
workmanship under normal use for a period of 90 days after purchase
and we will repair it free of charge or replace it at no charge, should it
become defective under this warranty, providing you submit proof of
purchase (sales slip) with the set.
During the initial 90 day period after original purchase, we will service
or exchange, at no charge, the set that is returned to LENOXX
ELECTRONICS CORP. After the initial 90 day period expires, and for a
period of 12 months from original purchase, we will repair the unit covering
any part(s) that need to be replaced at no charge, but will charge for the
cost of labor, return postage paid by LENOXX.
This warranty does not apply to any products which have been subject
to misuse, neglect or accident. This warranty does not cover broken
headphones or cabinet. UNDER NO CIRCUMSTANCES WILL LENOXX
ELECTRONICS CORP. BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state. The following charges apply to
repairs beyond the warranty period: $4.00. Be sure to pack carefully and
return postage paid insured together with your money order (personal
checks will not be accepted) and sales receipt to:
LENOXX ELECTRONICS CORP., 35 BRUNSWICK AVENUE, EDISON,
N.J. 08817, USA
For Customer Service
Dial: 1-800-315-5885 (MONDAY - THURSDAY 8:00 AM - 5:00 PM, FRIDAY
8:00 AM - 1:30 PM EST)
or Email: [email protected]
© 2006 LENOXX ELECTRONICS CORP.
35 BRUNSWICK AVENUE
EDISON, N.J. 08817, USA
MADE & PRINTED IN CHINA
6
IB-1126(CL)-WM-E-070506
|