LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
ARCH DOOR KITS WITH BRASS OR
BRUSHED STAINLESS STEEL TRIM
P/N 750,021M
REV. E 03/2008
INSTALLATION INSTRUCTIONS FOR ARCH DOOR KITS WITH BRASS OR BRUSHED STAINLESS STEEL TRIM
®
FOR USE WITH MERIT™, MERIT PLUS™, OR ELITE SERIES GAS FIREPLACES
Step 6.Open the glass door latche(s) located underneath the firebox.
KIT CONTENTS:
TOOLS REQUIRED:
None
1 ea. Arched Door
1 ea. Instruction Sheet
Step 7.Remove the door from the fireplace by swinging the bottom of
the door outward and lifting it up and away.
Step 8.Center the arch door over the glass frame as shown in Figure 1.
Press the arch door onto the glass frame and bend the four corner
tabs into the frame’s U-channel as shown in Figure 2.
GENERAL INFORMATION
These arch door kits may be used with gas fireplace models listed in
Tables 1 & 2.
CAT. NO.
81L34
MODEL
ADK35CPB
ADK40CPB
WHERE USED
EDV3530, ED3530
CAUTION
81L35
EDV4035, ED4035-2, LMDV-4035,
SSDV-4035, MPD4035, EDVST, EDST-2,
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR,
EBCR-2, EBVCL, EBCL-2
INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!
INSTALLATION INSTRUCTIONS
Part A: Elite Series Fireplaces
81L36
81L37
ADK45CPB
ADK24CPB
EDV4540, ED4540-2, MPD4540
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2,
EBVCL, EBCL-2
Step 1.Slightly lift and pull the existing top radiant panel/hood assembly
away from the fireplace, or pull hood and slightly lift and pull the
existing louver assembly away from the fireplace.
Step 2. Lift and pull the existing top and bottom bustle away from the
fireplace.
Step 3.Open the bottom compartment door (either a radiant panel or
louver assembly) by pushing in simultaneously the left and right
top corners of the door (the door is hinged at the bottom).
Step 4.Remove the bottom compartment door by sliding the hinge pin,
located at the door’s left side, to the right until it disengages from
the left corner post hole. Pull the door diagonally to the left, away
from the fireplace.
98L05
26M43
H7026
ADK33CPB
MDR3328, MDT3328, MPDT3328,
MPDR3328, LMDVR-3328
ADK35CMPB MPD3530, MPD35ST, MPD35PF, MPB35ST,
LMDV-3530, SSDV-3530
ADK22CMPB MPD35PF
Table 1 - Arch Door Kit with Brass Trim
CAT. NO.
98L68
MODEL
WHERE USED
ADK35CBS EDV3530, ED3530
Step 5.Remove the modesty panel as follows: lift the modesty panel by the
tabonthepanel’srightend, pulltherightendofthepanelawayfrom
cabinetandthenpullthepaneldiagonallyoutofthecornerpostslots
on the left side of the unit. Remove the modesty panel carefully, so
that none of the wires become loose or disconnected.
98L69
ADK40CBS EDV4035, ED4035-2, LMDV-4035,
SSDV-4035, MPD4035, EDVST, EDST-2,
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR,
EBCR-2, EBVCL, EBCL-2
98L70
98L71
ADK45CBS EDV4540, ED4540-2, MPD4540
ADK24CBS EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2,
EBVCL, EBCL-2
Arched Door
98L62
26M44
H7027
ADK33CBS MDR3328, MDT3328, MPDT3328,
MPDR3328, LMDVT-3328, LMDVR-3328
Glass
Frame
ADK35CMBS MPD3530, MPD35ST, MPD35PF, MPB35ST,
LMDV-3530, SSDV-3530
ADK22CMBS MPD35PF
Corner Tabs- At
The Four Corners
Figure 1
Table 2 - Arch Door Kit with Brushed Stainless Steel Trim
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
|